We Buy Hot Tubs

Guide · Homeowners · 3 min read · Updated 16 November 2026

Can You Sell a Faulty or Broken Hot Tub?

Short answer

Yes, many faulty hot tubs can still be sold. Tubs with repairable faults, such as a failed heater, pump, circulation pump, control board, topside panel or a minor leak, typically attract offers of £100–£800 in the UK, depending on brand, age and shell condition. Tubs with cracked or delaminating shells, widespread leaks or rotten frames are usually not worth buying, so removal and disposal is the better option.

An indoor tiled hot tub

Faults that can usually be repaired

Many hot tub failures involve components that can be replaced. A buyer who refurbishes tubs will price in the cost of parts and labour and still make an offer, provided the shell and frame are sound. The more precisely you can describe the fault, the more accurate the offer. If you have had an engineer look at the tub, share their findings or quote. That evidence often supports a better offer than an unexplained error code. Not every fault is as bad as it looks. A tub that will not start may simply have a tripped RCD, a flow error from a dirty filter or a loose connection. Check the basics, such as cleaning or removing the filters and making sure the water level is above the skimmer, before assuming a major failure.

FaultTypical causeEffect on offer
Not heatingFailed heater element, pressure switch or sensorReduced by repair cost; usually still buyable
Jets weak or not workingFailed pump, seized motor or blocked plumbingReduced; pump cost depends on model
Error codes on panelSensor, flow or control board faultsDepends on code; give the exact code
Topside panel deadFailed panel or control boardReduced; parts availability matters
Slow leakLoose union, perished seal or jet gasketUsually repairable; reduced accordingly
Circulation pump failedWorn bearings or seized impellerModerate reduction

Faults that usually rule out a sale

Some problems cost more to fix than a used tub is worth. Shell damage is the most common. Cracks through the acrylic, especially in the footwell or seats, blisters and delamination where the acrylic separates from its backing are very hard to repair to a standard a buyer would accept. Widespread leaks from multiple jets and pipework, rotten timber frames under the shell and severe frost damage throughout the plumbing can also make a tub uneconomic. If your tub has one of these problems, we will tell you honestly and can quote for removal and disposal from £250 instead. An honest assessment saves you time, and removal is often quicker to arrange than a sale.

  • Cracks, blisters or delamination in the shell
  • Leaks from many points rather than one
  • Rotten or collapsed frame under the shell
  • Severe frost damage across pipework
  • Obscure brand with no parts available for a failed control system

How to describe a fault

The best descriptions are specific and factual. Write down any error code exactly as it appears on the panel. Say what the tub does and does not do: does it power up, do the pumps run, does it heat at all or only slowly, and where does water appear if it leaks? Note when the fault started and whether anything happened before it, such as a power cut, a frost or a missed service. Photos help here too. Take one of the topside panel showing the error, one of any leak with the side panel off, and one of the equipment bay. If the tub has been switched off for a long time, say so, as seals and pumps can stiffen when left dry.

Should you repair before selling?

Usually not. If the repair is cheap and you can get an engineer quickly, fixing a minor fault may increase the offer by more than the repair cost. More often, though, the repair costs as much as it adds, and you carry the risk of further faults appearing. A buyer who refurbishes tubs can often fix faults more cheaply than a homeowner paying for a call-out. If you have already received a repair quote, share it. It gives a clear figure for the fault and helps everyone agree a fair price quickly. Some sellers try a cheap fix themselves, such as fitting a used part bought online. That can work, but a failed DIY repair or a non-matching part may reduce value further, so describe any work done when asking for an offer.

Safety with a faulty tub

Electrical faults on hot tubs should be treated with caution. If the RCD keeps tripping, the tub may have a fault such as water getting into the electrics. Leave it switched off at the isolator or socket and do not keep resetting it. If the tub is hardwired, any disconnection before collection should be done by a competent electrician in line with BS 7671. Drain the tub if possible to stop water sitting in a tub that is not circulating, as stagnant water can grow bacteria and smell quickly.

If we cannot buy it

When a tub is beyond economic repair, the parts still need to go somewhere responsible. Pumps, heaters and control packs are electrical waste under the WEEE Regulations 2013 and must be recycled at an authorised facility. The tub as a whole must go to a registered waste carrier under the Environmental Protection Act 1990 duty of care. Removal when we cannot buy starts from £250, with the tub drained, disconnected and removed whole or cut up, and you receive a waste transfer note. Removal is a clean end to a problem tub. It frees up the space, stops a broken tub from becoming an eyesore and avoids the risk of stagnant water or a damaged cover attracting pests. If the base, steps or gazebo are going too, include them in the same visit to avoid a second charge.

Questions people also ask

Will you buy a hot tub that does not heat?

Often, yes. A tub that does not heat usually has a failed heater element, pressure switch or sensor, which can be replaced. If the shell is sound and the brand is supported, we can make an offer that reflects the repair cost. Tell us any error code shown on the panel.

Can a cracked hot tub shell be repaired?

Small cosmetic chips can sometimes be filled, but structural cracks, blisters and delamination are very difficult to repair to a lasting, watertight finish. Tubs with this kind of shell damage are usually not worth buying, so removal and disposal is normally the better option.

My hot tub keeps tripping the RCD. Can I still sell it?

Possibly. Tripping often points to water in the electrics, a failed heater or a faulty pump. Leave it switched off, do not keep resetting the RCD, and tell us about the problem. If the shell is sound, the tub may still be worth buying once the fault is priced in.

Written and checked by the We Buy Hot Tubs team. Read our editorial policy.

Get a free we buy hot tubs quote

Tell us what you need and we'll come back with a clear price.

Request a quote